beaglebone-black - Flipbook - Page 81
BeagleBone Black
7.8 Ethernet
The board comes with a single 10/100 Ethernet interface located next to the power jack as shown in Figure
below.
Fig. 7.11: Ethernet Connector
The PHY supports AutoMDX which means either a straight or a swap cable can be used.
7.9 JTAG Connector
A place for an optional 20 pin CTI JTAG header is provided on the board to facilitate the SW development and
debugging of the board by using various JTAG emulators. This header is not supplied standard on the board.
To use this, a connector will need to be soldered onto the board.
If you need the JTAG connector you can solder it on yourself. No other components are needed. The connector is
made by Samtec and the part number is FTR-110-03-G-D-06. You can purchase it from http://www.digikey.com/
76
Chapter 7. Connectors
